D5 next zero l/h

[pau1er]

Have a nice day!

Is it possible to be overhead setup for D5 NEXT in way of 3m zmt and too many 90 degree adapters? Twisted it many times, no air jam i guess but not completely sure. Propyleneglicole as a coolant, 1100 ml approx. My first waku. Thanks!

 

[bundymania]

The awesome pump could easily handle 30 or more of those little buggers
You still got lots of air in your loop mate. Shake the whole case gentlly from left to the right like a baby and wait patiently. All will be good

 

[pau1er]

The awesome pump could easily handle 30 or more of those little buggers
You still got lots of air in your loop mate. Shake the whole case gentlly from left to right like a baby and wait patiently. All will be good

Thanks for your positive answer mate!
There was no air jam in the system. I made sure of that when i got disassembled some tubes and rad ports. Problem was appeared around highly viscous coolant - industrial grade propylenglycole for heating systems that i found to be useful for additives it contains. Once i flushed existing coolant and mixed it with hydrogen oxide in 1:1 proportion, it goes fine. D5 next's virtual sensor was never activated after that, but i found tip in calibration section saying that flow must be above 80 l/h at least. Hope, further mix with Destilliertes Wasser will be useful and enough
After a short first test, the temperatures are amazing.

 

[wwwnutzer]

The virtual sensor inside the next pump is more "guessing" than sensing, it's better to guess it yourself

So simply ignore it, as long as you see movement inside the reservoir and the temps look ok its probably fine