Suchergebnisse

next step? now that clocks are fine

this is all it says. 1708133890 also since we are talking clocks i have high perf powrplan right now, should i switch to balanced?

this is what im running rn its all auto with ACLL 0.15 and all limits removed + 400A iccmax. thoughts?

So VT3 runs normally at 1.17V die sense but SFT is running much lower clocks. Should I set avx offset to 0? I don't know what's going on here

I'm idling at 0.5V now, after leaving ring auto and just setting x8-54 and ecores auto. So how can I make my own curve, I've always used fixed vcore so I don't know about the tvb settings

I just used by core usage and set 2x60 and 8x 54, is that also forcing constant clocks? How else can I run lower clocks

Hello, For now I've set 6.0-5.4/4.2 with completely auto voltages and LLC 3. I set acll 0.11 and dcll 1.1(as per mohm table). What should I do next? I went a fair bit back reading all your posts yesterday but I haven't been able to figure what you mean by "tune your curve". Appreciate your help!

@Veii whats the difference between fixed vcore + LLC at static clocks vs default dynamic clocks and auto voltage in terms of ram OC. How does auto voltage help RAM? Like if I used a low acll for undervolt how is that better than manual core + LLC?

Tested in ycruncher VT3. If not SVID offset what method should I use for undervolt? Because vcore in adaptive with offset seems to do nothing. Perhaps IA AC/DC LL?

How can my config cause degradation? I'm running 5.4/4.2/48 @ 1.27V llc4 that's 1.092V under full load. My current is always<200A maybe some spikes but that's not even caught on hwinfo. Also, 8200 works at extremely low voltage which I didn't expect, 1.1SA 1.2TX and 1.3MC, so I was doubtful if...

Attached VF to this reply. And yes it's 1.27llc4 with cstates on + manual vcore and LLC. Iccmax is default possibly 511A. Bios 0081, dimms are cooled with a fan hit as high as 50+ in karhu.ring is set to 48/48 min max with down bin auto. MCH full check? It boots in seconds, extremely fast. Even...

Hey man. So I've tested individual channels on my encore+14900KF. It has MC 89 so I was super excited it would do 8400 but chB does 8400 no problem and chA fails no matter what I try. I've only touched CPU SA/tx/mc and ram.voltages. mrc FB on + MCH check on. Nothing else touched. Is there any...

I just got an mdie 8200 kit Hoping it would get me 8400 stable in VT3 but just like Adie it ended up hard walling at 8200. I have mrc fast boot enabled. I touched CPU SA tx and mc as well as dimm voltages and plls. Nothing has helped. Any suggestions as to what I should try next? It works...