Ratio CMOS Setting: 8.5
FSB Frequency: 450
CPU Clock Skew: Auto
NB Clock Skew: Auto
FSB Strap to North Bridge: Auto
DRAM Frequency: DDR2-901MHz
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual
1st Information:
CAS# Latency: 5 DRAM clocks
DRAM RAS# to CAS# Delay: 5 DRAM clocks
DRAM RAS# Precharge: 5 DRAM clocks
DRAM RAS# Activate to Precharge: 18 DRAM clocks
RAS# to RAS# Delay: 3 DRAM clocks
Row Refresh Recycle Time: 55 DRAM clocks
Write Recovery Time: 6 DRAM clocks
Read to Precharge Time: 3 DRAM clocks
2nd Information:
Read to Write Delay (S/D): 7 DRAM clocks
Write to Read Delay (S): 3 DRAM clocks
Write to Read Delay (D): 5 DRAM clocks
Read to Read Delay (S): 4 DRAM clocks
Read to Read Delay (D): 5 DRAM clocks
Write to Write Delay (S): 4 DRAM clocks
Write to Write Delay (D): 6 DRAM clocks
3rd Information:
Write to PRE Delay: 14 DRAM clocks
Read to PRE Delay: 5 DRAM clocks
PRE to PRE Delay: 2 DRAM clocks
All PRE to ACT Delay:6 DRAM clocks
All PRE to REF Delay: 6 DRAM clocks
DRAM Static Read Control: Disabled
DRAM Read Training: Auto
MEM. OC Charger: Enabled
Ai Clock Twister: Light
Ai Transaction Booster: Auto
Common Performance Level: Auto
PCIE Frequency: 100
CPU Voltage: 1.32500
CPU PLL Voltage: 1.55300
FSB Termination Voltage:1.32525
DRAM Voltage: 2.15725
North Bridge Voltage: 1.32525
South Bridge 1.5 Voltage: Auto
South Bridge 1.1 Voltage: Auto
CPU GTL Reference (0): +40mV
CPU GTL Reference (1): +40mV
CPU GTL Reference (2): +40mV
CPU GTL Reference (3): +40mV
NB GTL Reference: +60mV
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto
CPU Configuration:
Ratio CMOS Setting: 8.5
C1E Support: Disabled
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
wäre dir sehr dankbar dafür )
@ LaCroatino
joar bitte gerne
wobeis mir eigentlich lieber in text form wäre, da ich mit dem profil tool irgendwie nicht so zurecht komme, habs zwar schon zwei mal geschafft ein Profil wieder herzustellen, s lief aba irgendwie eigenartig ab..kA
aba ein deutliches "ja" zu deinem Angebot
(auch wenn ich skeptisch bin ob deiner settings bei mir gehen würden,allein schon wegen den unterschiedlichen GTL's und warsch unterschiedlicher VID,aba n versuch wäre es wert
ty very much
bin jetzt auch daheim, und werd mal was essen
ich berichte dann wies gelaufen is
ehm muss der stick, im FAT dateiformat sein? oda geht auch ntfs?
dacht ich mir schon...damnit..
aba ne nicht mal 1kb große datei auf a CD brennen? xDDDD never!
€dit: hab nen fat stick gefunden
beim laden des files -->"the file version is incompatible"
Ratio CMOS Setting: 8.5
FSB Frequency: 470MHz
CPU Clock Skew: Auto
NB Clock Skew: Auto
FSB Strap to North Bridge: 400MHz
DRAM Frequency: 940Mhz
DRAM CLK Skew on Channel A1: 300MHz
DRAM CLK Skew on Channel A2: 300MHz
DRAM CLK Skew on Channel B1: 300MHz
DRAM CLK Skew on Channel B2: 300MHz
DRAM Timing Control: Manual
1st Information:
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge:5
DRAM RAS# Activate to Precharge:15
RAS# to RAS# Delay: Auto
Row Refresh Recycle Time: 55
Write Recovery Time: Auto
Read to Precharge Time: Auto
2nd Information:
Read to Write Delay (S/D): Auto
Write to Read Delay (S): Auto
Write to Read Delay (D): Auto
Read to Read Delay (S): Auto
Read to Read Delay (D): Auto
Write to Write Delay (S): Auto
Write to Write Delay (D): Auto
3rd Information:
Write to PRE Delay: Auto
Read to PRE Delay: Auto
PRE to PRE Delay: Auto
All PRE to ACT Delay: Auto
All PRE to REF Delay: Auto
DRAM Static Read Control: Aktiviert
DRAM Read Training: Deaktiviert
MEM. OC Charger: Aktiviert
Ai Clock Twister: Moderate
Ai Transaction Booster: Manual
Common Performance Level: 11
Pull-in of CHA PH1: Deaktiviert
Pull-in of CHA PH2: Deaktiviert
Pull-in of CHA PH3: Deaktiviert
Pull-in of CHB PH1: Deaktiviert
Pull-in of CHB PH2: Deaktiviert
Pull-in of CHB PH3: Deaktiviert
PCIE Frequency: 100
CPU Voltage: 1,31250
CPU PLL Voltage: 1,57950
FSB Termination Voltage: 1,32525
DRAM Voltage: 2,18225
North Bridge Voltage: 1.33850
South Bridge 1.5 Voltage: 1,51325
South Bridge 1.1 Voltage: 1,1325
CPU GTL Reference (0): +30mV
CPU GTL Reference (1): Auto
CPU GTL Reference (2): +30nV
CPU GTL Reference (3): Auto
NB GTL Reference: Auto
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto
CPU Configuration:
C1E Support: Deaktiviert
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Disabled
CPU TM Function: Enabled
Execute Disable Bit: Enabled
Load-Line Calibration: Enabled
CPU Spread Spectrum: Deaktiviert
PCIE Spread Spectrum: Deaktiviert
Ratio CMOS Setting: 8.5
FSB Frequency: 480MHz
CPU Clock Skew: Auto
NB Clock Skew: Auto
FSB Strap to North Bridge: Auto
DRAM Frequency: DDR2-961Mhz
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual
1st Information:
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay: 3
Row Refresh Recycle Time: 50
Write Recovery Time: 6
Read to Precharge Time: 3
2nd Information:
Read to Write Delay (S/D): 7
Write to Read Delay (S): 3
Write to Read Delay (D): 5
Read to Read Delay (S): 4
Read to Read Delay (D): 5
Write to Write Delay (S): 4
Write to Write Delay (D): 7
3rd Information:
Write to PRE Delay: 14
Read to PRE Delay: 5
PRE to PRE Delay: 1
All PRE to ACT Delay: 6
All PRE to REF Delay: 6
DRAM Static Read Control: Auto
DRAM Read Training: Auto
MEM. OC Charger: Enabled
Ai Clock Twister: Auto
Ai Transaction Booster: Auto
PCIE Frequency: 100
CPU Voltage: 1,28125
CPU PLL Voltage: 1,50000
FSB Termination Voltage: 1,31200
DRAM Voltage: 2,10475
North Bridge Voltage: 1.31200
South Bridge 1.5 Voltage: 1,50000
South Bridge 1.1 Voltage: 1,10000
CPU GTL Reference (0): +30mV
CPU GTL Reference (1): +30mV
CPU GTL Reference (2): +30mV
CPU GTL Reference (3): +30mV
NB GTL Reference: +40mV
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: +37.5mV
CPU Configuration:
C1E Support: Enabled
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Enabled
CPU TM Function: Enabled
Execute Disable Bit: Enabled
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled