knX
Enthusiast
- Mitglied seit
- 20.11.2004
- Beiträge
- 4.249
wenn ich es richtig sehe, die zweiten Pins von rechts.
Sata I entspricht einem Durchsatz von 1.5 Gig.
€:
Hier stehts doch in der Anleitung:
NOTE : SATA 1.5Gb/s Speed Limit Jumper setting Only for SATA 3.0Gb/s products
In some rare cases SATA 1.5Gb/s hosts can not establish SATA interface connection with SATA 3.0Gb/s devices due to interface protocol
issues. In this case the jumper may be installed as shown on the figure below to force the device to negotiate for SATA 1.5Gb/s speed.
Sata I entspricht einem Durchsatz von 1.5 Gig.
€:
Hier stehts doch in der Anleitung:
NOTE : SATA 1.5Gb/s Speed Limit Jumper setting Only for SATA 3.0Gb/s products
In some rare cases SATA 1.5Gb/s hosts can not establish SATA interface connection with SATA 3.0Gb/s devices due to interface protocol
issues. In this case the jumper may be installed as shown on the figure below to force the device to negotiate for SATA 1.5Gb/s speed.
Zuletzt bearbeitet: