DFI LanParty JR X58-T3H6
Allgemeine Infos :
Das DFI LanParty JR X58-T3H6 ist das erste und bisher einzige µATX-Board für den 1366er High-End-Sockel von Intel. Es vereint eine geringe Größe mit dem grün-gelben Design, welches bisher nur für die LT/UT Serie von DFI vorgesehen war. Trotz des µATX-Formfaktors lässt die Ausstattung nicht zu wünschen übrig, es stehen 6 DDR3 Ram-Slots sowie 2 vollwertige PCIe x16 Slots zur Verfügung. Schon der Vorgänger auf dem 775er Sockel, das DFI JR P45, konnte durch eine gute Ausstattung, tolles Design und hohe Overclockingwerte begeistern.
Bilder :
Spezifikationen :
CPU
# LGA 1366 socket for Intel® Core™ i7 processors
# Intel® QuickPath Interconnect (QPI) technology - point-to-point interface that connects to X58; providing a dynamically scalable interconnect for increased bandwidth, lower latency and stability
# Integrated Memory Controller (IMC) supports 3 channels of DDR3
# Intel Hyper-Threading Technology delivers 8-threaded performance
# 6-phase digital PWM provides stable voltage to the CPU
Chipset
# Intel® chipset
- Northbridge: Intel® X58 Express chipset
- Southbridge: Intel® ICH10R
QPI
# System bus - 4.8GT/s to 6.4GT/s
System Memory
# Six 240-pin DDR3 DIMM sockets
# DDR3 1800(O.C.)/1600/1333/1066 MHz
# Triple-channel memory architecture
# Delivers up to 43.2GB/s bandwidth
# Supports non-ECC unbuffered DIMMs
# Supports up to 24GB system memory
# Windows® 32-bit operating system is unable to accurately detect more than 4GB system memory. Therefore, if you are using this operating system, we strongly recommend that you install a less than 3GB system memory.
Expansion Slots
# 2 PCI Express (Gen 2) x16 slots - 2-way SLI or Quad CrossFireX configuration at x16/x16 transfer rate lanes
# 1 PCI Express x4 slot
# 1 PCI slot
BIOS
# Award BIOS
# 8Mbit SPI flash memory
# CMOS Reloaded
Graphics
# Multiple GPUs - 2 graphics cards in 2-way SLI or Quad CrossFireX configuration
Audio
# Realtek ALC889 High Definition audio CODEC
# 8-channel audio output
# 108dB Signal-to-Noise ratio (SNR) playback (DAC) quality and 104dB SNR recording (ADC) quality
LAN
# Marvell 88E8053 PCIE Gigabit LAN controller with Teaming technology
# Fully compliant to IEEE 802.3 (10BASE-T), 802.3u (100BASE-TX) and 802.3ab (1000BASE-T) standards
Serial ATA with RAID
# Intel Matrix Storage technology
# Supports up to 6 SATA devices
# SATA speed up to 3Gb/s
# RAID 0, RAID 1, RAID 0+1 and RAID 5
IDE
# JMicron JMB368 PCI Express to PATA host controller
# Supports up to 2 UltraDMA 33/66/100Mbps IDE devices
Rear Panel I/O
# 1 mini-DIN-6 PS/2 mouse port
# 1 mini-DIN-6 PS/2 keyboard port
# 1 optical S/PDIF-out port
# 1 coaxial RCA S/PDIF-out port
# 6 USB 2.0/1.1 ports
# 1 RJ45 LAN port
# Center/subwoofer, rear R/L and side R/L jacks
# Line-in, line-out (front R/L) and mic-in jacks
Internal I/O
# 3 connectors for 6 additional external USB 2.0 ports
# 1 connector for an external COM port
# 1 front audio connector
# 1 CD-in connector
# 1 IrDA connector
# 1 CIR connector
# 6 Serial ATA connectors
# 1 40-pin IDE connector
# 1 floppy connector
# 1 24-pin ATX power connector
# 1 8-pin 12V power connector
# 1 4-pin 5V/12V power connector (FDD type)
# 1 front panel connector
# 6 fan connectors
# 1 download flash BIOS connector
# 1 diagnostic LED
# EZ touch switches (power switch and reset switch)
Power Management
# ACPI and OS Directed Power Management
# ACPI STR (Suspend to RAM) function
# Wake-On-PS/2 Keyboard/Mouse
# Wake-On-USB Keyboard/Mouse
# Wake-On-LAN
# Wake-On-Ring
# RTC timer to power-on the system
# AC power failure recovery
Hardware Monitor
# Monitors CPU/system/Northbridge temperature and overheat alarm
# Monitors Vcore/Vdimm/Vnb/VCC5/12V/V5sb/Vbat voltages
# Monitors the speed of the cooling fans
# CPU Overheat Protection function monitors CPU temperature and fan during system boot-up - automatic shutdown upon system overheat
PCB
# 6 layers, microATX form factor
# 24.5cm (9.64") x 24.5cm (9.64")
Bios :
Spannungsbereiche :
* CPU VID ~ 1.06255 - 1.60000V
* CPU VID Special ~ 100.23% - 114.88%
* DRAM Bus Voltage ~ 1.455 - 2.400V
* CPU VTTSpecial Add ~ +0.0125 - +0.1875V
* CPU VTT Voltage ~ 1.21 - 1.61V
* CPU PLL Voltage ~ 1.80 - 2.15V
* IOH/ICH 1.1V Voltage ~ 1.11 - 1.73V
* IOH Analog Voltage ~ 1.10 - 1.45V
* ICH 1.5 Voltage ~ 1.5 - 2.1V
* ICH 1.05V Voltage ~ 1.05 - 1.35V
* VREF Adjustments ~ 0.00 - +15.0%
Besonderheiten :
Ebenso wie beim Vorgänger, dem JR P45-T2RS lässt sich die Heatsink der NB ohne Garantieverlust entfernen und entweder durch einen Kühler à la HR-05 oder einen Wasserkühler ersetzen.
Passende Wasserkühler gibt es von :
- Mips
- EK Waterblocks + EK Waterblocks
- Watercool - nicht mehr verfügbar !
- Anfi-tec
Der Lochabstand an der NB beträgt 62mm !
Mittlerweile gibt es auch passende für die Mosfets :
- AnfiTec
- Koolance
Passende Kühler :
-> Luft :
- Prolimatech Megahalems
- Thermalright Ultra 120 extreme
-> Wasser :
- Watercool Heatkiller 3.0 (nur horizontal ! In vertikaler Lage kollidiert er mit den Kondensatoren !)
- Zern PQ+
Sonstiges :
- Spannungsmesspunkte :
Nützliche Links :
- Herstellerseite
- Preisvergleich
- Review im Barbonecenter
- Bios-Guide
Zuletzt bearbeitet:
..
) kann ich soweit nur weiterempfehlen. Übertakten kommt irgendwann mal noch...
... ruhig, brauner ... nur Geduld. 
